Chart practice

Do I need ATC authorization here? Reading the chart for Part 107

Under § 107.41 you need prior ATC authorization to fly in Class B, Class C or Class D airspace, or within the lateral boundaries of a Class E surface area designated for an airport (the dashed magenta line). You do not need it in Class G, or in Class E that starts at 700 or 1,200 ft AGL. On the chart, the question is which boundary you are inside and whether that sector reaches down to your altitude.

Last reviewed

The excerpts are cut from FAA sectional charts, edition effective October 29, 2026, with red numbered markers (areas) added by us. Sectional charts are updated every 56 days, so every reading below describes the excerpt as printed, not the chart you would buy today.

The legend rule

No person may operate a small unmanned aircraft in Class B, Class C, or Class D airspace or within the lateral boundaries of the surface area of Class E airspace designated for an airport unless that person has prior authorization from ATC.

Source: 14 CFR 107.41 (operation in certain airspace)

Part 107 remote pilots may fly in Class G up to 400 ft AGL, and within 400 ft of a structure, without prior coordination with ATC; in most cases Class E needs no authorization either.

Source: AIM 11-4-2 (Part 107 operations in Class G and controlled airspace); Remote Pilot Study Guide ch. 2 (Class E airspace)

Authorizations are obtained through the FAA's airspace access processes, including the FAA's Low Altitude Authorization and Notification Capability (LAANC) for near real-time approval, and are not arranged by calling ATC on the radio.

Source: AIM 11-8-2 (how drone airspace authorizations are coordinated); AIM 11-4-2 (Part 107 operations in Class G and controlled airspace)

Reading the chart: solid blue sector blocks are Class B, solid magenta are Class C (both MSL); a dashed blue line is Class D; a dashed magenta line is a Class E surface area. Part-time Class D or Class E surface areas carry an effective-hours note, and when one is not in effect it becomes Class E surface or Class G, as the Chart Supplement states.

Source: Chart User's Guide, VFR terms p. 16 (right traffic; Class B and Class C altitudes); Chart User's Guide, VFR terms p. 16 (Class D boundary, ceilings and part-time note); Chart User's Guide, VFR terms p. 17 (Class E surface areas, vignettes, Class G); AIM 3-2-5 (Class D airspace; part-time surface areas)

Worked examples

Example 1: Figure 101, area 2

Area 2 sits on a thick blue Class B line. Just north of that line (above the marker) the block reads 100 over SFC; south of it, 100 over 18. Does a drone flight at 150 ft AGL in the 100 over SFC sector north of the line need ATC authorization?

A sectional chart excerpt of a large city on a sound, with a long lake east of the city and a second city to the south-west. Solid blue rings and radial lines divide the area around the main international airport into sector blocks printed as a ceiling over a floor in hundreds of feet, dashed blue circles with bracketed ceiling boxes surround several towered airports, magenta airport symbols and seaplane anchors mark non-towered fields, blue tower symbols with elevation figures stand in the city, and magenta shading lies along the eastern foothills. Red numbered circles 1 to 7 mark points of interest. Open Figure 101, area 2 full size
Figure 101, area 2 Coastal metropolitan area with Class B sector blocks, satellite Class D airports and a seaplane base. Tap to zoom.
  1. The block just north of area 2 reads 100 over SFC in blue: Class B from the surface to 10,000 ft MSL. (The 100 over 18 block south of the line is a different sector, with a 1,800-ft MSL floor.)
  2. Because the sector starts at the surface, any drone altitude there is inside Class B.
  3. § 107.41: prior ATC authorization is required.

Reading: Yes. That sector is Class B down to the surface.

Source: Chart User's Guide, VFR terms p. 16 (right traffic; Class B and Class C altitudes); 14 CFR 107.41 (operation in certain airspace)

Example 2: Figure 104, area 2

Does the Class B sector at area 2 (100 over 19) apply to a drone at 400 ft AGL?

A sectional chart excerpt of a very large yellow built-up area on the shore of a great lake. Solid blue arcs and radial lines divide the airspace around a large international airport into blocks printed as a ceiling over a floor in hundreds of feet, a solid magenta circle with T-over-floor blocks surrounds a second airport to the south-east, dashed blue circles with bracketed ceiling boxes surround smaller towered airports, and dense blue tower symbols with elevation figures cover the city. Red numbered circles 1 to 7 mark points of interest. Open Figure 104, area 2 full size
Figure 104, area 2 Lakeside metropolitan Class B with two major airports, sector blocks, a Class C core and satellite Class D airports. Tap to zoom.
  1. Floor 1,900 ft MSL. The obstruction just below the block, 978 (344), puts the ground near 634 ft MSL.
  2. A drone at 400 ft AGL is at about 1,034 ft MSL, well below the floor.
  3. So this Class B sector does not require authorization for that flight. Whether anything else does depends on what is drawn underneath, so check for any dashed blue or dashed magenta line at your spot.

Reading: No, not this sector: its floor is about 1,266 ft above the ground. Then check the airspace beneath it.

Source: Chart User's Guide, VFR terms p. 16 (right traffic; Class B and Class C altitudes); Chart User's Guide, VFR terms p. 11 (obstruction symbols: MSL top, AGL height in parentheses); 14 CFR 107.41 (operation in certain airspace)

Example 3: Figure 110, area 3

The Waycross airport at area 3 has no control tower (magenta). Does a drone inside the dashed magenta circle need authorization?

A sectional chart excerpt of flat rural country with small towns, rivers and highways. Magenta-shaded rings surround several non-towered airports, two of which also carry dashed magenta circles, a large blue compass rose is centred on a navaid box near the centre, magenta hatched borders of military operations areas run along the left and top, grey military route lines cross the area, and blue tower symbols with elevation figures are scattered throughout. Red numbered circles 1 to 7 mark points of interest. Open Figure 110, area 3 full size
Figure 110, area 3 Rural pine country with Class E surface areas at non-towered airports, a VORTAC, military training routes and towers. Tap to zoom.
  1. Magenta data block: no tower.
  2. The dashed magenta circle is a Class E surface area designated for the airport.
  3. § 107.41 names that surface area explicitly, so prior ATC authorization is required inside it, tower or not.

Reading: Yes. A Class E surface area needs authorization even at a non-towered airport.

Source: Chart User's Guide, VFR terms p. 17 (Class E surface areas, vignettes, Class G); Chart User's Guide, VFR terms p. 15 (towered airports in blue, others in magenta; lighting codes); 14 CFR 107.41 (operation in certain airspace)

Check yourself

Three options each, as on the test. Pick one, then open the answer.

  1. A sectional chart excerpt of a river city near the coast with a large yellow built-up area. Solid magenta rings with altitude blocks surround the international airport north of the city, dashed blue circles with bracketed ceiling boxes surround a naval air station, a military field and an outlying field to the west and south, magenta shading surrounds many smaller airports, and clusters of blue tower symbols with elevation figures stand in and around the city. Red numbered circles 1 to 7 mark points of interest. Open Figure 108, area 2 full size
    Figure 108, area 2 River city with Class C sector blocks, several Class D airports and tall obstructions. Tap to zoom.

    Does a drone flight at 100 ft AGL inside the sector marked 40 over SFC at area 2 need ATC authorization?

    1. No: drones below 400 ft AGL never need it
    2. Yes: it is Class C from the surface to 4,000 ft MSL
    3. No: Class C begins at 1,200 ft
    Show the answer

    B. Yes: it is Class C from the surface to 4,000 ft MSL. The magenta 40 over SFC is the Class C core from the surface; § 107.41 requires authorization in Class C.

    Source: Chart User's Guide, VFR terms p. 16 (right traffic; Class B and Class C altitudes); 14 CFR 107.41 (operation in certain airspace)

  2. A sectional chart excerpt where brown shaded mountains with contour lines and a reservoir on the left meet an irrigated farming valley with a city on the right. A dashed blue circle with a bracketed ceiling box surrounds the city's airport, magenta shading with a hard outer edge borders the valley, thin grey lines with route numbers cross the mountains, blue tower symbols with elevation figures stand on ridges, and magenta private-airport symbols with elevation and runway figures are scattered through the valley. Red numbered circles 1 to 7 mark points of interest. Open Figure 103, area 6 full size
    Figure 103, area 6 Mountain-edge valley with a Class D airport, Class E shading, private strips, obstructions and military training routes. Tap to zoom.

    A remote pilot wants to fly at 300 ft AGL over the private airstrip at area 6, where no Class B, C or D boundary and no dashed magenta line is drawn. Is ATC authorization required?

    1. No: the airspace there from the surface is Class G
    2. Yes: every airport requires ATC authorization
    3. Yes: Class E starts at the surface near airports
    Show the answer

    A. No: the airspace there from the surface is Class G. With Class E starting at 700 or 1,200 ft AGL, the airspace at 300 ft AGL is Class G, where no authorization is needed. A private strip does not create controlled airspace.

    Source: Chart User's Guide, VFR terms p. 17 (Class E surface areas, vignettes, Class G); Remote Pilot Study Guide ch. 2 (Class G airspace); 14 CFR 107.41 (operation in certain airspace)

  3. A sectional chart excerpt of a very large yellow built-up area on the shore of a great lake. Solid blue arcs and radial lines divide the airspace around a large international airport into blocks printed as a ceiling over a floor in hundreds of feet, a solid magenta circle with T-over-floor blocks surrounds a second airport to the south-east, dashed blue circles with bracketed ceiling boxes surround smaller towered airports, and dense blue tower symbols with elevation figures cover the city. Red numbered circles 1 to 7 mark points of interest. Open Figure 104, area 5 full size
    Figure 104, area 5 Lakeside metropolitan Class B with two major airports, sector blocks, a Class C core and satellite Class D airports. Tap to zoom.

    Is ATC authorization needed to fly at 200 ft AGL inside the dashed blue circle beside area 5?

    1. Yes: it is Class D airspace
    2. No: Class D starts at 3,300 ft
    3. No: only Class B and C need authorization
    Show the answer

    A. Yes: it is Class D airspace. A dashed blue line is Class D from the surface (here to 3,300 ft MSL); § 107.41 requires authorization.

    Source: Chart User's Guide, VFR terms p. 16 (Class D boundary, ceilings and part-time note); 14 CFR 107.41 (operation in certain airspace)

  4. A sectional chart excerpt of a large city on a sound, with a long lake east of the city and a second city to the south-west. Solid blue rings and radial lines divide the area around the main international airport into sector blocks printed as a ceiling over a floor in hundreds of feet, dashed blue circles with bracketed ceiling boxes surround several towered airports, magenta airport symbols and seaplane anchors mark non-towered fields, blue tower symbols with elevation figures stand in the city, and magenta shading lies along the eastern foothills. Red numbered circles 1 to 7 mark points of interest. Open Figure 101, area 1 full size
    Figure 101, area 1 Coastal metropolitan area with Class B sector blocks, satellite Class D airports and a seaplane base. Tap to zoom.

    Over the water at area 1, does the Class B sector printed there (100 over 30) apply to a drone at 400 ft AGL?

    1. Yes: everything inside the Class B rings needs authorization
    2. Yes: Class B extends up to 10,000 ft
    3. No: this sector's floor is 3,000 ft MSL, far above the drone
    Show the answer

    C. No: this sector's floor is 3,000 ft MSL, far above the drone. The sector runs from 3,000 ft MSL to 10,000 ft MSL. Over water near sea level, 400 ft AGL is far below its floor; any airspace beneath it is a separate reading.

    Source: Chart User's Guide, VFR terms p. 16 (right traffic; Class B and Class C altitudes)

  5. A sectional chart excerpt of a desert city ringed by mountains, with a large yellow built-up area and a lake to the east. Solid blue rings with ceiling-over-floor altitude blocks surround the main international airport, dashed blue circles with bracketed ceiling boxes surround several towered airports, a magenta hatched border crosses the top-left corner, and blue tower symbols with elevation figures stand across the city. Red numbered circles 1 to 7 mark points of interest. Open Figure 106, area 3 full size
    Figure 106, area 3 Desert metropolitan area with Class B sector blocks, satellite Class D airports and obstructions. Tap to zoom.

    The North Las Vegas tower (area 3) shows a star after its frequency, and a nearby note reads See NOTAMs/Supplement for Class D/E (sfc) eff hrs. When the tower is closed, what applies to the surface area?

    1. The Class D stays in effect 24 hours
    2. It becomes Class E surface or Class G, as published; check the Chart Supplement and NOTAMs
    3. It becomes part of the Class B
    Show the answer

    B. It becomes Class E surface or Class G, as published; check the Chart Supplement and NOTAMs. A part-time Class D surface area reverts to a Class E surface area or Class G; the Chart Supplement entry says which. If it is Class E surface, § 107.41 still applies.

    Source: AIM 3-2-5 (Class D airspace; part-time surface areas); Chart User's Guide, VFR terms p. 15 (airport data: elevation, runway length, CT, star, CTAF); 14 CFR 107.41 (operation in certain airspace)

Common slips

See where you stand on the whole test

Chart reading is one part of the Part 107 test. The free Muster Check covers all five test areas in the proportions the real test uses and shows the cited source for every answer.

Take the free Muster Check

More chart practice

Chart excerpts: FAA VFR sectional charts (public domain), markers added. Rules: FAA Aeronautical Chart User's Guide, Aeronautical Information Manual, Remote Pilot Study Guide and 14 CFR part 107. Independent study tool. Not affiliated with or endorsed by the FAA.

Tap the image to zoom in; drag or scroll to move around.